5-Axis 2500/12 Flame And Plasma Automatic CNC Pipe Cutting Machine

A. Function of 5 Axis 2500/12 Large Size Flame CNC Pipe Intersection Cutting Machine:

1. Below photo was taken during commissioning of Wuxi JACK 5 Axis 2500/12 Flame CNC Pipe Cutting Machine: (Fig.1)

2. The Max. Workpiece that can be Cut in 5 Axis 2500/12 machine on large size pipe cutting is cross section diameter Φ2500mm and 12m long:

A piece of large diameter being cut and beveled from Wuxi JACK flame cut machine:  (Fig.2)

3. Same as the previous model of 5 Axis 2500/9, here the product 5 Axis 2500/12 is the replenishment on early models of CP series Plasma Oxygen fuel CNC Pipe Intersection Cutting Machine, catering for the sub-division on more segmented workpiece size.

B. Detail Delicacy in Wuxi JACK Large Scale Flame CNC Pipe Cutting Machine:

1. With nearly 20 years of development, the CP series automatic machine on pipe cutting with plasma Oxygen fuel, sees many improvements involving structure design, assembly and component, hardware and software of control system, etc.;

2. Compared with the machine at its inception stage, this advanced technique automatic machine of today becomes nearly new version. It makes progress toward the target of best safety, better quality, more consistent performance, and easier operation, under the principle of Wuxi JACK “Continuous Improvement”;

3. Example on Cable and Oxygen Fuel Tubes Arrangement in Wuxi JACK Flame CNC Pipe Cut Machine:

One of these improvements is the arrangement on oxygen fuel gas pipe and cable, throughout the whole traveling stroke of cutting torch in the machine:

1) At the early stage of CP series automatic machine, the oxygen fuel gas pipes were hanged overhead alongside the equipment, especially in the small model of 3 Axis 600mm specification models;

2) And cables were laid within drag chain. The drag chain was put onto floor closely with the machine mechanical frame. Please check below picture:

Cable and gas tube routing in early small models of Wuxi JACK CNC Pipe Cutting Machine: (Fig.3)

3) in Flame CNC Pipe Cut Machine:

Such way of arrangement has 2 issues and problems of

a) The CNC Pipe Cutting Machine itself does not have good appearance (Oxygen fuel pipe had better be placed invisible);

b) Due to the close distance between cutting torch and cable, there exist certain degree of safety potential risk to the machine operation, that sparks may be generated during cutting process, which in turn cause cable into burning;

4) Today, the placement of cables and oxygen fuel pipes inside the machine, especially large size heavy duty models is improved in large extent:

Please check below picture:

a) Cable and gas tubes routing in updated Wuxi JACK large CNC Pipe Intersection Cutting Machine:  (Fig.4)

b) As shown in the above photo, the cables and oxygen fuel pipes are laid into the same slot with half meter interval, and in the height level right above the entire set of CNC Pipe Intersection Cutting Equipment, deployed on the operating platform;

c) In this way, the previously mentioned safety hidden risk can be eliminated reliably;

d) Besides, the whole set of large machine has more compact and concise appearance.

C. Technical Parameters of 5 Axis 2500/12 Large Scale Heavy duty CNC Pipe Intersection Cutting Machine: