SXBJ-4 Double Milling Head High Efficiency Plate Beveling Machine
Home » Products » Plate Beveling Machine » SXBJ-4 Double Milling Head High Efficiency Plate Beveling Machine
Share to:

SXBJ-4 Double Milling Head High Efficiency Plate Beveling Machine

Quantity:

The SXBJ-4 High Efficiency Plate Beveling Machine is very similar in terms of edge milling range and application case as SXBJ-3. (Most often seen such kind of Sheet End Milling Equipment at industries of Construction Machinery and Engineering Machinery). The only difference is SXBJ-4 has 1m longer available edge milling stroke than that of SXBJ-3. And the reason there exist SXBJ-4 besides SXBJ-3 is, at some facilities, the max. edge milling necessary for structure member is 3m, while at some other facilities it is 4m. Purchase of large-scale equipment such as this plate bevel machine should be tailored to optimum utilization rate, and this is the reason SXBJ-4 is another most used model of Sheet End Mill Equipment. And same as SXBJ-3, the primal reason for introducing 2 milling heads to 4m long Sheet End Mill Equipment is for doubling productivity.

 

 For best performance of SXBJ and XBJ plate beveling machine, regular in-control lubrication on the milling heads is an indispensable step of daily maintenance. Manual lubricating pumps are fit on the milling units. For each time of lubrication, around 10 droplets of lubricating oil should be dropped onto top and bottom rails within one minute, ensuring constant lubricating film on the surface of the rails. Also because of small volume of lubricating oil consumption, work site floor can be kept clean and will not be contaminated. Please check picture as below:

 2- Lubrication

For precise chamfering machine of SXBJ and XBJ Sheet End Mill Equipment, as well as its heavy workload, service of the machine is very important. For this Wuxi JACK has complete introduction on maintain of the plate bevel machine in its manual book, and will give training to customers to make sure good operation of the plate beveling machine.

 

Below is specification of the SXBJ-4 Double Milling Head High Efficiency Plate Beveling Machine:

 

No.

Parameter

Value

Note

1

Max. length of   plate machined one pass

4000mm


2

Plate   thickness

6-50mm


3

Distance from   pack to worktable

80mm


4

Milling angle

Top milling unit

0° to +45°

Adjust by manual

Down milling unit

-45° to 0°

5

Edge Milling   speed

   130∼1000mm/min. (VFD, Inverter Control)

6

Idle Speed

   4000mm/min.

 

 


Home

WUXI AMASS MACHINERY CO., LTD
WUXI JACK TECHNOLOGY CO., LTD
0510-83297829
English Language: 15852755799; 
Chinese Language: 13621515089
No. 2, Ouyang Road, Runyang Village, Yang City, Luoshe Town, Huishan District, Wuxi City
© Wuxi AMASS Machinery Co., Ltd  2021 All Rights Reserved.

CONTACT US